Adjustable Sliding Door Guide

thingiverse

Adjustable door guide for sliding closet doors. Modeled after the worn out original I replaced in every room of my home.To print:I used PLA, which works fine, but PETG would be a bit stronger and more resilient.Supports are needed for the inner guide.Print one inner and two outer pieces.To install:• Remove the old guide• Remove the front (outer) door• Slide the back (inner) door to one side• Position the inner guide so the tall piece is just a little in front of the door, and the edge of the door is just past center of the guide• Screw the inner guide in place• Insert the outer guide under the back edge of the inner guide and position just a little behind the door. Screw in place• Hang the front (outer) door back in place• Insert the second outer guide under the front edge of the inner guide and position just a little in front of the door. Screw in place