Adjustable Resin Vat Stand

thingiverse

This station has adjustable height and depth for most resin bottles. The pictures are all using the v1 parts. None of the v2 parts have been print tested as of the time of this upload. The v2 base has a taller mounting point for the 8020 extrusion to allow room for taller bottles, and top cap and slightly taller v2 funnel and vat holder mounts. The v2 funnel and vat holder mounts have been modified so that the T-nuts would not be able to fully rotate to insure they are always locked into place. All parts are oriented in the intended printing orientation and only the funnel needs supports. Cura - Support Overhang Angle between 45 & 50 for minimal supports. The mounts have holes to use thumbscrews and T-nuts on either side but both aren't necessary. Non-printed parts include 6.5 mm dowel rod. 4x T-nuts 2x Thumbscrews 4x 5m screws Glue I also put a small screw and washer in the back of the dowel rods to prevent them from pulling out.