Adjustable RC Car Stand w/ Shocks Station

cults3d

This is a Custom RC Car Stand that I built to work on my Traxxas E-Revo 1/16 (it's sized so that it fits the MERV perfectly, but should be able to hold larger models as well).\n\nFeatures:\n* Spins freely in all directions (360 degrees)\n* Adjusts height easily by turning the M20 nut to lift or lower - totally independent of rotation\n* Four sets of holes for holding shocks: 10mm, 13.5mm and 15mm\n* Special holes to hang shocks upside down for draining oil are placed above oil trays for easy dripping \n* Multiple trays for storing parts (including one separate for front / back)\n* Depending on your printer and settings, prints in about 15 hours and uses approximately 140 grams of filament (which brings the cost at around $3, so much cheaper than ordering from online retailers like AliExpress) \n\nI used some strips of rubber I had lying around for stability, and you can use furniture feet stickers from any DIY store as well.