Adjustable lamp hood - ø 60 cm

cults3d

Elegant bell to 3D print and install over any simple and boring ceiling bulb, turning it into an elegant adjustable lamp to read or give a nice atmosphere to your bedroom or dining room, with its 60 degrees approximate swivel, you can direct the light directly on the dining table, place to read or study. 4 different "shade" designs. During assembly, take 1 meter of rope and knot it in half, then wind two turns on the piece "pinion _ rope" letting two ends hang from both sides of the diameter of the piece, this will allow to operate the mechanism by pulling one of the two ends. Installation is simple and safe directly on the rosette (lamp holder, bulb holder, etc.) with the two screws that hold it to the ceiling. Attached assembly and installation video in a .rar file. If you have questions, try to ask me in the comments, I'll be attentive.