Adjustable BLTouch/3DTouch mount for Re-D-Bot

thingiverse

The new mount from aleknest is now adjustable to change the space between the bottom plane of the sensor and the bed. Installation: 1) Use an M3 countersunk screw to install the fixed part of the mount on the carriage. 2) Secure the sensor to the moving part with two M3 screws and self-locking nuts. 3) Set the required distance from the lower plane of the sensor to the table surface using a caliper, following the 3D Touch manual's recommended 8.3 mm setting. Lock the caliper in place at this distance. 4) Insert the movable part with the sensor into the groove on the fixed part mounted on the carriage. 5) Move the Z axis manually or use the steppers control to touch the bed surface with a nozzle. 6) Place the caliper vertically next to the sensor, then move the sensor until its lower plane coincides with the caliper body's lower plane. 7) Lock the mount at this distance by tightening the short M3 screw in the side hole of the groove. It is recommended to print the new mount using PETG with 100% fill and a layer height of 0.2-0.25 mm.