Adjustable BL-Touch sensor mount for Ender 3 and CR10 REMIX - 1mm Thicker mount

thingiverse

Here's a tweaked version of the mount plate with just one modification - it's now 1mm thicker to accommodate an M3 lock nut that fits snugly into its pocket, approximately 4.5mm deep. This design isn't optimized for printing and would benefit from being printed in a flat orientation with supports. The pockets for the fan shroud tabs make this necessary. I recommend using the support interface as well for best results. Thanks to Cofifield for verifying that an M3 lock nut fits perfectly. Since the thickness has increased by 1mm, you'll need to adjust the offset by the same amount. If you end up making this, please share your feedback - it's greatly appreciated!