ADIMLabs HCMaker 7 Z Stepper Mount

thingiverse

After upgrading to a MicroSwiss Extruder hotend combo I needed a Z Stepper motor mount that would allow the Z axis to go lower since the microswiss was raised up more than the stock extruder. I could not find any mounts that would work without modifying my z-lead screw mounts as well, so I designed this one. This allows the motor to remain close to the 2020 extrusion as the stock one did but allows the z-axis to go lower! The t-nuts I have are very small so I put a groove in the inner part of this mount to allow you to screw on the t-nut before hand, then using a flat head screwdriver you can pop the mount in to place with the t-nuts on. It is a tight fit but it does work out well.