Additional parts for fully printable PM-9

thingiverse

You need all the original parts except for the Bolt connector. With this you can fully print the PM-9 without having an Airsoft and if you have the right spring you can even rack bolt and drop it with the trigger. I hope the picture explain enough but if there are any questions just send me a message or comment. The current Magazine does not engage the mag release perfectly! The way it currently is the magazine has some wiggle room up/down when inserted. It stays in place and does not come out unless you press the release but it could be better.... Not sure if I'll bother with adjusting the cutout by a few milimiters until it's perfect, probably not since that's good enough for my decorative use case. https://shop.jkarmy.com/amg-recoil-spring-for-sig-air-vfc-p320-m17-gbbp-winter-use.html Here's where you could get the spring which I used, it is 9USD. You could also just glue the bolt closed/open if you don't want it to be moveable.