Addi Express Foot Extender

thingiverse

Addi machines usually come with two metal clamps that grasp the feet tightly and clamp them to the table firmly. I've noticed several others attempting to use a bar clamp to hold the top of the machine in place, but that approach doesn't always work out. My design aims to cradle the feet and extend them slightly for better stability. It's recommended to print these pieces upside down to minimize support requirements. Observe how the feet are designed to fit snugly into place, with a small gap left for easy attachment to the leg. Note that I measured the feet at approximately 32mm in diameter and the leg at about 22.5mm in width. Print Settings: Printer Brand: FlashForge Printer: Creator Pro Rafts: Doesn't matter Supports: Doesn't matter Infill: Since it will be clamped, a recommended infill level is over 50% Notes: I've successfully printed these parts using both ABS and PLA. While ABS may cause some shrinkage, resulting in an extremely tight fit, PLA proved to yield better results for me.