Adapter 2 inch (ocular side) to 1,25 inch (telescope side)

thingiverse

# Telescope Adapter 2 inch to 1,25 inch For use with my 2 inch barlow on my 1,25 inch telescope focuser. This adapter is hard to find for purchase. # Print Instructions Rotate the adapter so the 2 inch side faces down. I used a small amount of sandpaper to ensure a snug fit on the 1,25 inch side. Printed in ASA: I experimented with scaling and achieved excellent results at 101.5 percent. However, this may vary depending on the material and printer used. # Test Print Always make a test print on the 1,25 inch side. Use the test print circle with a brim to ensure proper alignment. Check if the result is suitable for your focuser. Remember: it's always better to print slightly larger and then trim with sandpaper than to start small and risk damage to your focuser.