Adaptateur Extrudeur+ Dagoma DiscoEasy

thingiverse

Hello, I added a module to the base Extruder+ so I only need to print and be able to print flexible filament without having to buy the Extruder+ from Dagoma. To do this you must: - Print all parts of the file - Clean up your prints properly - Remove your base extruder - Remove the small ball bearing and insert it into the designated spot on the new arm - Install the arm with the spring onto your extruder body - Insert the PTFE tube guide into the largest hole of the adapter - Insert the adapter with the smallest hole into the extruder body at the designated spot - Make sure the filament goes in and comes out correctly without forcing it too much - Put back your extruder There you go! I hope this tutorial helped you.