Adaptador sensor filamento sunlu S8 a BMG

thingiverse

I've found that the Bowden of the Sunlu S8 can be swapped out for a BMG dual extruder but it ends up misaligned with the filament sensor. To fix this, I drilled a 4mm hole in the entry point of the filament sensor using a drill bit to allow a 4mm teflon piece to fit and prevent wear on the entrance, then printed an STL file that matches the screw holding the sensor support so it can be screwed onto the new part. If desired, a small piece of teflon tube can be placed between the two parts, making sure the sensor and Bowden are properly aligned.