Adafruit Metro ESP32-S2 (Beta) case

thingiverse

This is a snap-together case for the Adafruit Metro ESP32-S2. This was designed based on two samples of the Beta board. Tolerances may vary, and eventual production boards may differ. I printed this in PETG at .2mm layer height. The case has a groove on one side. Slide the board into the groove at an angle, and then seat the board. I inset this so that the on/off switch is slightly accessible. The board probably snaps in place well enough for casual use. It can be secured with 1-4 m3x5 screws (I use 2 diagonally opposite cap-head screws). There are cutouts to view the board led's. Cutouts also are present that should allow access to the headers with standard square body jumpers, subject to build tolerances. The case top snaps onto the bottom. The friction fit pins also somewhat help hold the board if it isn't secured with screws