Adafruit Feather ESP8266/ESP32 Cases

youmagine

Human: These cases are compatible with a variety of Feather boards including:\n\nAdafruit Feather HUZZAH with ESP8266 WiFi: https://www.adafruit.com/product/2821\n\nAdafruit HUZZAH32 - ESP32 Feather Board: https://www.adafruit.com/product/3405\n\nFeather ESP8266\n\nTop Cover\n\nChoose one of the following options:\n\ncover-feather-slotted.stl: A case cover with slots cut in the top for wire. The end slots can be used to fish in wiring that has already been attached or soldered during prototyping.\n\ncover-feather-top-closed.stl: Fully covered/closed top.\n\ncover-feather-slotted-top-hold.stl: If your machine doesn't print the bottom cases' pins quite right, snap off the top portion and use this cover. It presses against the USB port and PCB antenna, so preferably use this as a last option.\n\nBottom Case\n\nSelect one of the following options:\n\nfeather-esp8266-bottom-closed.stl: A case with no cutouts for headers.\n\nfeather-esp8266-bottom-slotted.stl: A case with cutouts on the bottom for headers.\n\nfeather-esp8266-bottom-header-shrouded.stl: A flipped case for boards that have male headers soldered for breadboarding. Use with any top and female dupont-style headers.\n\nFeather ESP32\n\nThe ESP32 shares top covers with the ESP8266, so pick any of the ones above and add a bottom case.\n\nTop Cover\n\nSelect a cover from the ESP8266 section above.\n\nBottom Case\n\nesp32-feather-bottom.stl: This case has the rear pins cut in 'half' so that they fit. Since the ESP32 Feather module covers part of the rear holes, some rework may be needed post-print depending on filament/printer tolerances (or just snap them off and try the top-hold cover).\n\nesp32-feather-bottom-slotted.stl: An ESP32 case with slots for headers going out the bottom.\n\nSi7021 Humidity/Temperature Sensor Breakout Case\n\nThe top and bottom of the Si7021 Humidity/Temperature Sensor case are designed around this specific board: https://www.adafruit.com/product/3251