Adafruit CricKit Cup (Holder)

thingiverse

This is a holder for the Adafruit Crickit that doesn't require standoffs or screws to use. It's an easy print and can be used to protect the bottom of the CricKit. The above pictures were printed in nylon using a UM3 and PETG using an FFCP. For printing with nylon, you should use the CrickitCupNylon.stl file. I found that the tolerances are slightly smaller than expected and my UM3 produced good results. Your printer may or may not have the same effect. These holders fit the Crickit without screws, which means they can be used with a CPX or Feather without being screwed in. If you need to use them on a Crickit with screws (with a CPX or Feather screwed in), check out the file named 'screw'. This design was updated June 9, 2018.