Action Pharah

thingiverse

UPDATE 3/17/2017: "UpperArmGuards" were added since they were missing from the initial upload. The instructions file has been updated to reflect this addition. UPDATE 10/31/16: "ElbowGuards" was uploaded as a GCODE file instead of STL, and I have corrected the error. Please read the "Pharah Instructions.pdf" for detailed information. Seriously, the print settings are too long to fit here, and this project is not suitable for new users - experienced makers only should attempt it. This file is scaled in inches. If your build volume is smaller than a FlashForge Creator Pro (8.85 x 5.7 x 5.9 in or 22.5 x 14.5 x 15 cm), you cannot make this print unless you break the files down into smaller pieces. Print Settings: Printer: PowerSpec 3D Pro Rafts: No Supports: Yes Resolution: 0.1mm Infill: 30% Notes: Some parts need support, while others don't - use common sense (see above about experienced makers only!). Details are in the PDF. The PowerSpec 3D Pro is a re-badged FlashForge Creator Pro. Post-Printing: Finished. Top view. Seated. Close-up.