Action camera TPU case

thingiverse

Hello all! I required moderate protection for my action cameras, specifically the Eken H9 and H9R models, so I could drop them without worrying about damage. This case also allows me to use power banks instead of the included battery, though you can still use it with the battery if you prefer. Please note the following: 1. Use this case with caution and at your own risk. 2. It may work with other action cameras like the SJ4000, but I'm not sure about that. If someone could confirm this, please leave a comment with the name of the camera used. 3. You'll need to reorientate the part in your slicer before printing it. 4. My printing settings worked for me, but they might not work for you. Feel free to use your own settings if needed. 5. Be careful when removing the prints, especially the buttons, as they have a small membrane that's 0.3mm thick. This case provides basic protection for your action camera, and it's probably worth printing. Please note that I used 15% infill, but you can increase it to 100% for extra protection. I printed this with my modified CR-10 using Chinese TPU at 60mm/s speed and 0.2mm resolution. You might want to decrease the speed to 15-20mm/s and the resolution to 0.12mm to make it work on your printer. Don't use any support or bed adhesion, and be careful when removing the prints, especially the buttons. They have a small membrane that's 0.3mm thick, which is an essential part of the design to prevent the button from falling off after installation.