Acoustic Guitar strap button to replace the 1/4" jack strap button when you remove the pickup from an acoustic guitar

thingiverse

Originally, I had a pickup on my flat-top acoustic that attached to the soundhole and connected its signal through a combination rear strap button/1/4" jack. However, I decided to get rid of the electronics. To replace it, I made a new piece to fit where the combo 1/4" jack/strap button was located, but used orange plastic which seemed a bit unsightly. Please exercise caution when using this design; it's on a guitar that is neither heavy nor valuable, and if I had an expensive acoustic or planned to jump around with it, I would have concerns about the strap attachment's strength. To use this design, measure your guitar first, and for mine, I sized it at 17mm on the x-y axis and 35mm on the z-axis. Print with a raft, and after printing, find a wood screw that fits appropriately to keep the prongs from collapsing (to maintain the peg in the guitar). Again, exercise caution as this design has not been extensively tested.