Accessory on/off switch for Anycubic Kossel Plus (for e.g. Raspberry Pi

thingiverse

This is an accessory switch design meant to fit snugly between the lower extrusions in an Anycubic Kossel Plus. I'm unsure whether it will also fit the smaller Anycubic Kossel versions, so please test and let me know. The switch can be used for any accessory, such as a Raspberry Pi or LED strips. This design is part of several mounts to integrate a Raspberry Pi into the base of your Anycubic Kossel. Other mounts can be found in the links below: Raspberry Pi mount: https://www.thingiverse.com/thing:3912074 Power supply mount: https://www.thingiverse.com/thing:3912130 There are several versions in this download, each with its own specs listed in the filename. - A version fits a 5mm LED. - A simpler version comes with an on/off label. Both versions are available for switches with a 5, 6, 7 or 8mm mounting hole. The optional LED can be pressed into place. For a typical 20mA LED, a 580 ohm resistor will work fine. Mount to the 2020 extrusions using a M4 screw and T-nut / hammer nut.