ABR-3M parts & accesories

thingiverse

A few remixes I've made for my ABR-3m based on my experience and preferences. I gutted the middle shell as I couldn't get cages with motors to fit, so I kept the same profile and isn't pretty to look at inside but should accommodate motors now. Be sure to enable the print thin lines setting as the shell gets a bit thin in the middle. This is version 2.0 which I haven't tested yet. My first remix required a touch of dremeling still, but not much, so I remixed it to hopefully eliminate that issue, but I don't plan on reprinting it unless I need to, so I haven't tested it. I deleted the rear screw hole from middle shell as well as the space for the volt meter because the bar from the rail interferes with mag insertion. I scaled up a muzzle brake to fit the end of 3/4 pvc for an orange tip, and pvc will need to be sanded a touch as it's a tight fit. I remixed the stock, added side rails, deleted lettering and solenoid holes, so the solenoid will be hot glued into place. It is secure, and I didn't like the 2 screws in the side there. I enlarged the area around heat set insert holes on the rear shell as experience showed there wasn't enough, and the area warped. I remixed the barrel as flat top and deleted screw bar at rear of the original barrel because I found it interferes with mags, and it holds up fine without it. I added a picatinny rail to both sides of the shell front. I designed a pseudo-ish P-90 sight that will friction fit on either the standard rail or my flat top rail. However, I superglued mine on. Including a 42.5mm OFP GEN2 stryfe cage with rotated dart guide. I added a 40mm daybreak cage and a 41.5mm daybreak cage.