Above Ground Pool Top Cap

prusaprinters

I was asked to model this top cap for an above ground pool based on an old one what was deteriorating.  I do not know the make or model of the pool or part (installed by 3 Brothers Pools if that helps), but I have included photos of the original.  The recipient is very happy with the results and said it fit perfectly.  It prints on its side without supports.Since people tend to lean on these and they are outdoors and exposed to the elements (and chlorine) I would suggest printing in ASA/ABS, or at minimum PETG.  I would also suggest printing it with at least 4 perimeters and 20% infill.  Probably overkill, but this is the type of thing that will probably take some abuse.