AA and AAA Battery Holders (2, 4, 8, 12, 16 packs)

thingiverse

Here is a set of AA and AAA battery holders. No support needed, as these holders feature retention that keeps your batteries securely in place. Perfect for tossing a pack into a bag and heading out. It took 2 hours to print the 4AA pack at a resolution of 0.3MM with an infill percentage of 20%. Print Settings: Printer: FLUX 3D Delta Rafts: No support needed Supports: None required Resolution: 0.3mm Infill: 20% Notes: Printing at resolutions as low as 0.2mm or 0.1mm will reduce the amount of sanding required to remove any marks on your AA batteries. Post-Printing: A light touch with some fine-grit sandpaper is all that's needed to eliminate any marking on the batteries. Simply sand the retention "bump" at the top of the holder, and you're good to go! How I Designed This: I used Tinkercad.com to bring this design to life.