AA 6 and 8cell battery holder

cults3d

Added an 8 cell holder. I designed this AA battery holder for my GAME MAN handheld console (https://cults3d.com/en/3d-model/game/nintendo-game-man-oversize-game-boy-famicom-hack) The 3D printed negative terminal spring loops have a 0,2 mm gap on the bottom to prevent them from adhering too well to the base. Use pliers to snap them loose from the bottom by squeezing them gently. Loop 3,5 mm (or thinner) desolder ribbon through the slots and around the poles and connect the banks of cells according to the top down photo with the red lines as guides. Good soldering skill is required. Use flux and be quick with the soldering iron so as to not melt the plastic too much when tinning the braid to lock it in place. It should only take less than a second of heat to achieve a good seal. Bumps on each side of the + poles prevent reverse insertion of the batteries. Solder braid (with my affiliate code):https://www.banggood.com/1_52_02_53_03_5mm-Desoldering-Wire-Suction-Tin-Desoldering-Wick-Solder-Braid-Wire-for-PCB-Tin-Remove-Welding-Tool-p-1528549.html?p=HD240528697332015103&custlinkid=1370570