A10M/A20M Purge Wipe / "Bucket" - Remix

thingiverse

Purge bucket remix https://www.thingiverse.com/thing:3372835 - A file "complete" to print with support - Or using glue with 2 parts without support ... Slic3rPE Cleanup python script remix https://www.thingiverse.com/thing:3194394 - Add a message on the printer screen with: Current Layer / Total Layer - Current Tool Change / Total Tool Change - Remaining Time - Clean useless G-code, hardcoded retract by Prusa etc... when using wipe tower - Add M501 (load config from eeprom) code before the first G... - Adjust the first "retract" in tool change script.. (using ;TOOLCHANGE_RETRACT comment) because slic3r does NOT de-retract extra retract_length_toolchange on the first use on a Tool - Add M104 Sxxx (temperature) using correct layer temperature for current extruder. If you use PVA... - The script purges by default 40 mm of filament, but if you set filament_minimal_purge_on_wipe_tower (filament - advanced - minimal purge on wipe tower) the script uses it. !!! The value in Slic3r is a volume mm3 - ie if you want 60 mm length purge , you should enter 144 in mm3 (60 * ~2.4 ) ( 1.75^2 x Pi / 4) - The script needs this code in printer custom G-code section --> After layer change G-code ;AFTER_LAYER_CHANGE --> Tool change G-code ;TOOLCHANGE_START T[previous_extruder] TO T[next_extruder] ;TOOLCHANGE_TEMPERATURE {first_layer_temperature[next_extruder]} {temperature[next_extruder]} G92 E0 {if retract_length_toolchange[previous_extruder] <= 0}G1 E-{retract_length[previous_extruder]} F{(retract_speed[previous_extruder]*60)+1}{endif} {if retract_lift[0] == 0} G91 G1 Z0.4 F{(travel_speed*60)-1} G90 {endif} G1 X1 F{(travel_speed*60)-2} G1 X-10 Y{if previous_extruder == 0}175{else}60{endif} F3000; {if retract_lift[0] == 0} G91 G1 Z-0.4 F{(travel_speed*60)-3} G90 {endif} T[next_extruder] {if retract_length_toolchange[next_extruder] <= 0}G1 E{retract_length[next_extruder]} F182{else}G1 E{retract_length_toolchange[next_extruder]} F182{endif} G1 E{max(40,filament_minimal_purge_on_wipe_tower[next_extruder] /2.4)} F223 {if retract_length_toolchange[next_extruder] > 0} G1 E-{retract_length_toolchange[next_extruder]} F{(retract_speed[next_extruder]*60)+2} ;TOOLCHANGE_RETRACT T[next_extruder] {endif} G92 E0 ;TOOLCHANGE_END T[previous_extruder] TO T[next_extruder]