A10 Filament runout mounting bracket

A10 Filament runout mounting bracket

thingiverse

If you have the original Geeetech A10 that was supplied without a filament runout sensor, this may help you install one. I acquired one of these items from eBay at the link below. I installed it onto the existing mounting point by the extruder using a bolt, leaving it slightly loose so that the bracket can pivot freely. The switch sensor is then attached to the bracket as shown in the image, again leaving the screw slightly loose so that the sensor can pivot freely. Finally, I secured the nut on the bolt with glue so that it wouldn't work its way loose. Here's a link to my modification of the firmware; it may only be relevant to Marlin Version 2. https://www.facebook.com/download/preview/248176362533708 Sensor: https://www.ebay.co.uk/itm/3D-Filament-Detection-Module-Filament-Run-out-Pause-Detecting-Monitor-Sensor-EL/323457179135?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649

Download Model from thingiverse

With this file you will be able to print A10 Filament runout mounting bracket with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on A10 Filament runout mounting bracket.