A tap (faucet) for a 10 litre oak barrel

thingiverse

OK I guess this could be considered a remix. Personally I consider it a redesign. I designed the original it was just not good. I redesigned it but it was way too small for my barrel. The third iteration was slightly too big and the taper was too severe. I didn't want to cut a larger hole in my quite expensive oak barrel so I redesigned it a bit. I reduced the angle of the taper and made the tap handle and the various holes larger for the fourth and I hope final iteration. It is printing as I type this. It is being printed in generic red PLA (it was on the machine) on my Tronxy XY2 Pro Titan, with supports touching the bed and 40% infill. I will try printing with wood filled PLA when I get some ;-) The Print is looking good so far.