A simple Raspberry Pi (2, 3) and Raspi Cam holder

thingiverse

A Simple Holder for Raspberry Pi and Camera I built my setup around a Raspi 2 and a raspicam v2. To mount this support, replace the two left pillars of Anet Board (see attached pictures). The design is straightforward with simple camera orientation to allow remote print checking using octoprint or similar setups. Feel free to share, print, and post comments to improve this design! Print Settings Printer: Anet A8 Rafts: No Supports: No Resolution: 0.2 Infill: 10-15% Notes: Used PLA. Post-Printing What You Need... You can use the same screws of the Anet Board to fix the raspiholderlight2.STL to the Anet frame. Four M2.5x20 screws and four M2.5 nuts are required to secure the raspberry pi to the holder. Alternatively, you can carefully enlarge the raspberry pi holes to fit M3 screws. You will also need one M3x30 screw and one M3 nut to fix the camholderlight2.STL to the raspiholderlight2.STL. Custom Section