95X naked GoPro cinewhoop

thingiverse

A 95X version of my naked GoPro Cinewhoop. Uses the same case as the 85X, so you can easily move it from one to another. I've included both a 5-degree and 10-degree case. Even with 5 degrees, you shouldn't see the FPV cam because of where it's mounted. If you check my 85X files, there's a lens protector and an ND filter holder you can also print in TPU. Files labeled HARD are meant to be printed in PETG or PLA. PETG is preferable for strength and temperature resistance, but up to you. HARD_v2 (two files) is the newest case that accommodates buttons. Watch the how-to video here: https://youtu.be/um8lrao-Oo8. SOFT files are made of TPU. You could print the case itself in TPU, but I've never tried it and don't know how well it will protect your GoPro. M2x10mm screws are required for each motor. Test this yourself! Make sure the screws don't touch the motor windings. I used M2x8 screws only for the front two screws of the battery tray, leaving the two rear self-tapping screws in place. The little TPU thing sticking out the top is for either your VTX or RX antenna. Personally, I have my RX out the top and my VTX out the back for less interference. 0.2 layer heights are used, with supports yes. For the GoPro case, use supports and a brim. Check out these parts: https://rotorbuilds.com/build/21981.