90mm Cradle Extended (up to 82 mm!)

thingiverse

This is another remix of the cradle, utilizing pins from the source once again.\nThe cradle accommodates spools ranging in size from as small as 61mm, minus the outer walls, to as large as 82mm, including the outer walls.\nWhile the thinner bearing support can comfortably hold a 1kg spool, I recommend inserting the pin through the stronger support first, as depicted in the accompanying pictures. Under pressure, this thinner support may bend slightly toward the other support.\nIt's possible I could have made the opposing side's outer support even thinner, but upon measuring with Meshmixer, the size of 82mm proved sufficient for the Monoprice Orange ABS spool I had on hand.\nIf anyone desires a thinner outer support on this side, please indicate so in the comments section.\nThe process of creating this cradle was slightly more challenging than my smaller counterparts, necessitating additional slices to maintain the desired proportions.\nIn essence, if you only reduce the scale and slice the outer support for one bearing, the resulting space between the two supports will be less than that required for a single bearing. To resolve this issue, I sliced the middle section between the two supports, allowing me to scale up the cradle while maintaining the necessary space for the bearings.\nFor reference, I've included the Meshmixer file for your convenience.\nPrint Settings:\nPrinter: Monoprice Maker Select V2\nSupports: No\nResolution: 0.1 mm\nInfill: 20\nNotes: Printed with 0.8 mm walls and top/bottom layers.