90 degree bracket for 80mm x 20mm Aluminum v-slot linear rail

thingiverse

This is a straightforward 90-degree bracket for the V-slot linear rail from Open Builds. The holes are countersunk, specifically designed to accommodate the M5 - 8mm low profile screws from Open Builds. I required a bracket to secure some rail that would hold my spool of filament. Rather than searching for one on Thingiverse, I decided to learn Fusion360 and create one for myself. Please note: This bracket is larger than the Open Builds angle bracket. Observe in the pictures there is some overhang. This will not be an issue if you are only using this in the corner. Refer to the pictures for a clearer understanding of what I'm describing. I printed this with the angled face facing down on my heated bed, and it turned out perfectly for me. No modifications were necessary when attaching it to my printer. I intend to print this tomorrow. Slic3r advises that it will take approximately 1.5 hours on my Voxel with 1.75mm PLA filament and a 0.4mm nozzle. Your results may vary. Good luck with your printing endeavors.