8x8 LED Matrix bezel (MAX7219 modules)

prusaprinters

<p>A bezel for mounting three 8x8 LED matrix displays next to one another.</p> <p>The bezel is designed to glue to the surface it is mounted on to (MDF for example).</p> <p>Alternatively drill holes at each end and use mounting screws.</p> <p><strong>Version 2</strong></p> <p>This version improves on version 1 with larger bezel providing more surface area to glue to the surface. Also opened up the squares that the LED matrix sit in so that a friction fit is no longer used, thus light glue is recommended to fix them in place.</p> <p><strong>Version 1</strong></p> <p>The LED matrix are a friction fit into this model. I placed the LED matrix without PCB module on a flat surface face down then placed bezel over the module from behind, tapping the back of the bezel with a light hammer to fit. This gives a friction fit without the need for glue etc - perhaps not for the faint hearted! You need to watch for first layer squish reducing the size of the holes, run around inside edge with a dremel or knife if required to open the holes up to correct size.</p> <h3>Print Settings</h3> <p><strong>Printer:</strong></p> <p>CREALITY CR-10</p> <p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div> <p><strong>Supports:</strong></p> <p>No</p> <p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0.2</p></div> <p><strong>Infill:</strong></p> <p>20%</p> </p></p> Category: Signs & Logos