8mm LED Strip Mount (remix)

thingiverse

I noticed the original models were designed to accommodate a 10mm wide LED strip, whereas my strip measured only 8mm. In response, I created an entirely new mount strip based on the original design, specifically engineered to hold two strips of 8mm each. The channel in the back of this design features tight clearances that effectively direct your lighting exactly as intended. Each strip is precisely 215mm long. On June 19, 2017, I observed that this model proved too narrow for the LED strip width. Until a revised, slightly wider model can be uploaded and made available, it's recommended to print this STL at a scale of around 103% to 105%. This adjustment will make it easier to insert the LEDs without compromising the mounting hole on the back.