8mm Bearing Block Z

thingiverse

This *should* be a push fit replacement for the Z-Carriage part on the Hypercube. I created to replace my existing parts with as little changes as possible. I print it at 95% flow in Cura. Increasing or decreasing the extrusion can change the fit quite a lot. It's especially tight over the 2020 extrusion because that's the fit I was aiming for. The Step file is included because you may well need to alter it slightly so it prints well on your printer. Initially I printed https://www.thingiverse.com/thing:2427740 and it seemed okay but then I found it had a tendency to break along the front end and I already had my bed setup for the original parts so decided to see if I could combine the two and come up with a replacement I could just swap into place.