8520 motor mount - wing

thingiverse

See original thing/file for typical thermoplastic FDM printing information if available. I enlarged this remix, because my motors were too big after test print from Photon Mono (SLA). I also added a hole for wires in the back, and removed half of the mount, to make this an underwing mount for planes with a high wing. I installed with hot glue, works fine. Used "ERYONE" brand black "ABS-Like Resin" from amazon, with the following print settings on my Photon Mono SLA printer: Layer thickness: 0.050 Normal Exposure Time: 3.50 Off Times: 0.5 Bottom Exposure Times: 40.00 Bottom Layers: 6 Anti Alias: 1 No raft, supports, or hollow. Rotated X or Y until biggest flat side with slot faces down, Z to center and avoid FEP stress. Print Time: 52 Min Resin Used (Calculated by slicer): ~3.182ml