80 Series Land Cruiser dashboard pocket

pinshape

A Replacement Pocket for Above the Stereo This pocket is designed to replace the factory one above the stereo. It's flat and deep, with a cutout in the back that allows a cable to pass through. For optimal results, print this pocket with its faceplate facing upwards. This will minimize unnecessary supports and mess. To-Do List: Increase the size of the faceplate by about 1mm in height and 2mm in width. Model two angled tabs on the sides, which are currently broken off my factory pocket. These tabs prevent the pocket from sliding too far into place. Two self-sprung/live ratchet style anchors are needed at the top of the pocket to hold it securely in position. Round out the corners for a smoother finish. Print Settings: Printer: Anet A8 Rafts: Yes Supports: Yes Resolution: 0.15mm Infill: 20% Notes: Print this pocket with its faceplate facing upwards, which means that the tabs on the faceplate will have supports. Printing it any other way would result in a messy and difficult-to-clean cavity.