80 My Customized Snap-Fit Blower Fan Duct ()

thingiverse

Using the following options: Fan bolt diameter is set to 4.4mm. Thickness of all parts will be 1.2mm. Notch length from edge to be cut will measure 10.85mm at this setting. Notch offset value, for precision cuts only, has been adjusted to 0.91 units from the specified notch width. The design incorporates the following features: A counterbored hole, of diameter 10mm, positioned 2 units above the base plate. Dimensions and measurements: Inner radius of the elbow is set to a precise value of 1/200 of an inch. Angle of the elbow: an optimal 80 degrees, ideal for stability. Nut diameter is precisely measured at 7mm in this model design. Height of fan nut has been established at 2 units. Base bolt height has been adjusted to fit within 3 unit boundary. Customization settings applied include: Tip width of base assembly is currently set at 3 units. Tip length of outer plate reaches an impressive measurement of 25mm units from center. To ensure optimal fit and balance in the finished assembly, tip distance is fixed at precisely 20mm apart.