7HP / 8HP 7x Attenuator Mult Eurorack Module

thingiverse

A neat little 7HP / 8HP (two front panel designs) 7 x attenuator / mult. Inputs in the left socket are attenuated and output to the right socket. Inputs in the left socket are also multipled to all left sockets below until a jack is plugged into a left socket, so for example if you plug a signal into the top left jack, you get 7 mults of that signal each with their own attenuation. To complete the module you need: - 14 sockets: https://www.taydaelectronics.com/3-5mm-mono-enclosed-socket.html - 7 Pots: https://www.taydaelectronics.com/100k-ohm-linear-taper-potentiometer-round-knurled-plastic-shaft-pcb-9mm.html - Hook up wire. I wired up all the pots first and then went row by row. I've included a picture showing a single row wired up for the attenuator only. For the mult functionality wire from the top rear pin to the bottom rear pin of the next socket down for each socket in turn. Components click into the support structure with a bit of pressure, and can be removed with a small flat screwdriver from the back of the support. The ground pin on the sockets needs to be folded in under the socket to fit. Printing: 0.2mm, 60% infill, brim recommended.