.75" mounting bracket modules for shelving system

thingiverse

This model was designed based on a custom version of http://www.thingiverse.com/thing:725453, made using Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=725453. Below are the steps to create this model. The Following Options Were Used: * notch depth set at 30 units * amount of connectors is 4 in number * this part serves as the bottom unit due to false classification under its_a_bottom_part category * edges fillet size adjusted to 7 units * board hole size measured to be 3 units square * offset for grounding was calculated to be 16 units from top * it includes insert holes for both boards and braces as it is marked true in insert_hole_for_board and insert_hole_for_brace, respectively * the brace hole's depth reaches up to 20 units from ground level * the width of foot was fixed at 30 units as measured on a standard basis * length for notch part stands out to be around 35 units * bottom unit was classified false for having connectors oriented in 90 degrees angle under straight_1_connector_bottom parameter * it consists zero amount of back parts since this option remains unassigned * minimum required shell thickness was considered while creating this model at the level of 2 units only.