73.1/69.1

thingiverse

A 3D printer part was created online, a custom modification of a design available at thingiverse.com. The customized object is derived from the "Inner cone 2" model by the user and made using Customizer! The Customizer tool can be accessed directly here. This custom print job features a number of specifications: Height - The object is printed at 10 units tall. Inner cone- There will be an inner cone of just one in total number. Ridge thickness- This 3D print model features ridges that are 0.25 units wide throughout its design. Cone amount - It consists of a couple cones overall within the entire model. Outer measure- When complete, this print will be roughly seventy-three and ten thousandths inches around externally from its outer edge or periphery. This dimension does represent what would normally be described as being the object's diameter if this particular item had no taper to it whatsoever so the "diameter" concept makes most sense with regards here; hence "Outer measure." Clearance - The custom object leaves approximately three tenths units of space between where each cone intersects, providing some clearance. Angular detail level- This is defined in $fn equals twenty-five sixty units (i.e., "a little bit high polycount" level). Height of the ridge above base of outer surface - When you look at this part with ridges and then observe its very tip - there is an increase relative height wise; amount is two. Size at inner portion before reaching where cone(s) meet main part: approximately sixty-nine point one units from said edge toward that location (for instance). The ridge shifts about 3 full size unit length horizontally, or "ridges shift sideways."