(7 module/52V )Nissan Leaf Module DIY Battery Pack Cover and Cable Management

thingiverse

UPDATE: Recommend downloading "leaf_biscuit_small" as the latest, most compact version for printing. Best joinery technique is used in this variant, which employs #8-32 screws. A remix of 5 module cover is created, with a new variant of cable exit that allows users to have low current "sense" wires exiting one way and (+) and (-) leads exiting separately. A split body design is added to make printing easier by dividing the large single piece into two manageable parts. Bolt holes are strategically designed to accommodate either #10-32 or M6 screws, with hex voids on the back side fitting 3/8" or 10mm wide nuts - a common width for both types of screws. However, users may need to drill out the holes slightly to fit M6 screws through.