6mm Rod End Bearing/Rose Joint

thingiverse

I had to replace my G2S rod end bearings with something temporary until new ones arrived. These spacers have a 6mm center hole and an M6 thread at the base, but all sizes are exact with no tolerance, so you may need to drill or tap some areas depending on your printer's accuracy. To assemble these spacers, you'll need two M3 x 8mm screws, and I recommend using an M6 nut to secure the rod-end to the rod. Threadlock might not be sufficient in this case. I printed my spacers in PLA, but they're a bit stiff and creaky. However, they work fine, and lubrication or using a different material like nylon should help them move more smoothly.