6cm Diameter 9 seedling pot holder

prusaprinters

<p>After printing several of the previous version it became obvious that some help was needed to drain excess water off the top. I have designed this one, same pot holder just a few channels and holes to allow water to drain through.</p><p>Added to print que, once printed will add photos.&nbsp;</p><p>Ok photos added tried several times to print with base supports but without success early on in print cycle so tried without.</p><p>Very scruffy result needed sanding and a craft knife to get to this. I have half a roll of prusament blue left rather than the sunlu I used but saving it.&nbsp;</p>