608 bearing Version 1

prusaprinters

<h3>Work in progress</h3><p>Sooo don't expect this to work as well as a steel bearing. It is a bit of a pain to get the bearing to work after your print is finished. but it will act as a bearing once you finish it.</p><p><strong>version 2 is now availible: </strong><a href="https://www.prusaprinters.org/prints/131996-608-bearing-version-2"><strong>https://www.prusaprinters.org/prints/131996-608-bearing-version-2</strong></a><strong>&nbsp;</strong></p><p>Let's start with printing settings :)</p><h3>Print settings:</h3><p>layer height: 0.12mm</p><p>supports: no</p><p>Printing speed: just go with regular printing speeds this will make it easier in the end</p><p>brim/ raft: no (unless your first layer is really bad then yes)</p><p>material: i used PLA</p><h3>Print is finished</h3><p>after when the print is finished the fun part begins :)</p><p>You will need to move all bearing on by one in other to break them fully loose. This can be done whit a pen or any other small pointy object.</p><p>After you break them loos you will notice the bearing is probably still stuck. You will just need to play around with the bearing in other to let it run smoothly. This can be done by attaching it to an axle and just rolling it around like a fidget toy. You can also apply pressure on the sides or push the inner ring out of the bearing BUT not FULLY, So be careful how much pressure you apply on that side.</p><p>&nbsp;</p>