60 Round Holder for Magpul Backpacker X-22

prusaprinters

<p>This is a partial remix of and inspired by <code>u/along_for_the_ride11</code>'s awesome <code>BAK-1 100 Round Holder for Magpul Backpacker X22</code> that I purchased from them. I have received permission from them to share my variant. Please see <a href="https://www.reddit.com/r/1022/comments/rwxcy2/stl_files_for_magpul_backpacker_x22_and_other/">HERE</a> to purchase their files.</p><p>The holes in the brick can occasionally be too tight. Either press a tad harder or take an empty .22 casing and push it through the hole (as suggested by <code>u/along_for_the_ride11</code>).&nbsp;</p><p>This ammo holder was designed to fit in the rearmost compartment of the <a href="https://magpul.com/hunterx-22backpackerstock-ruger10-22takedown.html?mp_global_color=118">Magpul X-22 Backpacker</a> stock using the high cheek riser lid ONLY. It will not likely fit with the low cheek riser lid.</p><p>The reason for this design was to allow a <a href="https://www.tandemkross.com/doublekross-mag-body-ruger-1022">TandemKross DoubleKross</a> magazine to fit in the middle compartment while still allowing for as much "loose" ammo storage as possible without rattling or noise.&nbsp;</p><p>The high cheek riser lid will require minor modification to allow the magazine and ammo holder to fit. The rear reinforcement rib will need to be removed and the small fins near the latch may also need to be removed. I used some <a href="https://www.amazon.com/Hakko-CHP-170-Stand-off-Maximum-Capacity/dp/B076M3ZHBV">Hakko-CHP-170 Micro Cutters</a> for this.</p><p>Printed in Prusament PLA with 0.2mm Speed profile, 100% Infill and supports everywhere.&nbsp;</p><p>Printed on MK3s+ with 0.4mm default nozzle.&nbsp;</p><p>If you have any questions, let me know.</p>