6 Round Speedloader

thingiverse

This is a Speedloader designed for 357 magnum six-shooters such as the Ruger GP100 or S&W 586. Watch a video describing the loader and watch it in action here: https://youtu.be/rWkl5VvpVYA. Print Settings Printer Brand: MakerGear Printer: M2 Rafts: Doesn't Matter Supports: No Resolution: .25 or less Infill: Any Post-Printing This loader prints in 4 parts and glues together so that it can be printed without supports. After printing, Take the "gear bottom" piece and put it into the "cylinder bottom" from the flat side. Then take the "gear top" and place it over the "gear bottom" piece so the notches line up. Glue the two gear pieces together, ensuring that no glue gets on the cylinder. After the first step has set, Take a toothpick or similar item and dab some glue along the edge of the top of the "cylinder bottom" piece that the gear pieces are not attached through. Be careful not to get any glue close to the holes, as this could affect the fit of the bullets. Then, take the cylinder top piece and place it on top of the cylinder bottom so the holes line up, ensuring that no glue gets on the gear pieces. Use a clamp while the glue sets (if you have one) to ensure a tight fit.