6" Ramps case with 80mm fan and TL smoother mounts, PCIE or EPS power input.

thingiverse

NOTICE: PLEASE MAKE SURE OF YOUR POLARITY. An 8-pin EPS motherboard auxiliary power plug is reverse polarity from a PCIE 8 pin. PCI Express has ground on the clip side of the plug, while EPS has +12v on the clip side. You can use either one, but be sure to wire your RAMPS up appropriately and label them properly. Remixed the case to mount an 80mm fan and 2 or 3 TL smoothers on the lid. The 3x smoother lid may not clear the LCD, and the plugs in the rear may not fit properly either. >►01/17 - Added a longer version of the case. This one is 155mm long, offering more room behind the 80mm fan. Also added a 4x smoother lid. >►01/18 - Added Two rear panels with five hole GX16 connectors and a hole for a panel mount PCIE 8 pin connector to power everything. These 8 pin connectors carry 3-4 x 7.0-9.0A 12v legs, which should be enough for most printers. Added four more back plates with the Power in slot labeled for either PCIE or EPS respectively. This keeps one from forgetting how they wired it. Although PCIE and EPS are keyed differently, they're similar enough to warrant care when working with them. Two of the backplates have the barrel jack of the Arduino covered up. Here's more reading on the PC power cables: http://www.playtool.com/pages/psuconnectors/connectors.html#eps8 Ordered 30 Pcs 4.2mm 8P 8 Pin Female Power Connector For PC Computer CPU Plastic Shell from the slowboat. The connectors are labeled as EPS, but it won't be confirmed until they arrive.