6" Rack, RAMPS Full LCD

thingiverse

Note: If you need access to the SD card from the front, an SD-card extender cable will be required. However, I haven't attempted this, as I've been using OctoPi without SD cards and don't own an extender cable myself.\nThis version allows for SD access from the side, but if you rack mount it, you won't be able to reach the slot.\nYou can print a cap if you don't need all the plugs on the rear plate. The holes are 16mm in diameter and designed for microphone jacks.\nEnsure there are no cables between the fan and heat sinks. This design is optimized for CNC machines, which consume significantly less power than 3D printers. You may need an additional fan directly attached to your heat sinks for 3D printing purposes.\nI relocated the Piezo sensor to the back of the PCB to bring the screen closer to the front plate. In retrospect, I probably should have removed it altogether, as it can be quite distracting when in use.\nPlease let me know how this print turns out.