6" racing quad fully printed

thingiverse

Hi, This is my fully printed racing drone for 6" props. I printed this with ABS at a 0.2mm layer height and a plate temperature of 110°C. The arms must be completely flat without warping, or the flight behavior can become worse. So far, it has resisted even my bad flying style ;-) For the frame, you will also need some M3 x 30 screws and some pt 2.5mm screws (or other screws that fit directly into plastic). It's designed to be used with these parts, but it can also work fine with other components that fit in the frame: - Motor: Turnigy 2205 2600KV with Dalprop 6030 (quite fuel-saving) for better performance, a smaller prop would be suggested. - ESC: 4in1 30A 31x31mm (a lower rating would also be okay for this kind of motor). - VTX: Eachine TX805 with smart audio. - FC: F4 NOXE 20x20mm. If you just fly in Acro mode, you could also use a 31x31mm FC and place it over your ESC. Then it's not completely centered, but that doesn't matter if you only want to use the gyro and no acceleration. Have fun!!!