6 Inch Pyramid Lamp

thingiverse

Human uses a six-inch single wall nightlight that features one jumbo super bright LED (3.5 volts, 30 milliamps). A voltage-limited design consists of an eleven-volt wall transformer connected to a two seventy-ohm quarter-watt resistor to prevent excessive current flow. This circuit enables easy mounting of the on/off switch with a built-in slot and cavity. The nightlight has a black base, a translucent red shade, and a clear cap. Printer Settings: Printer: Z605 by RepRap Rafts: No rafts are needed for this design. Supports: This nightlight does not require any supports during printing. Resolution: I've left the resolution open to adjustment based on the desired appearance of the light's shade. A lower setting may be preferred for a more subtle effect, while a higher setting will create a more pronounced glow. Infill Percentage: Ten percent infill was used to achieve an adequate balance between density and structural integrity. This value can be adjusted to meet specific needs. Notes: I printed this nightlight with a .4 millimeter nozzle, 0.26 layer height, and a speed of sixty millimeters per second for optimal results.