6 Cup Moka Coffee Tamper Set

thingiverse

Human: The Moka pot setup is simplified with Tamper and Ring attachments that make preparation easier and less messy. These attachments ensure that the coffee grounds stay put inside the container, preventing them from seeping onto the top surface where they can clog the gasket. I made a previous upload disappear by accident but this version includes exactly the same steps.\n Instructions to print these useful tools:\nPrinting:\nThe files for these designs were created on a Replicator Dual using 2 colors. \nPrint quality was set at 0.2 mm Layer height: with supports enabled.\nPrint Tamper on its own, as per my recommendations.\n\nPrinting the upper sphere can be quite tricky! While it doesn't need any support, there's always a risk of under-cooling and then not sticking properly. In this case I made some tweaks to the print settings around that area which seem to help a lot - and even more if you give it a little air blow with your mouth before it fully cools off!\nI did two-color printing for both ring and ring-stripe - these should go together in one job.\nThe color bar on this is located at exactly the same level as your container, serving up as visual signal to see how much coffee beans you put into it already so do remember that too because if you don't fill right after pouring some coffee powder will still climb on surface again tomorrow afternoon! Print out base part along with other separate ones namely coffee bean also use color difference - since platform ensures proper level placement between objects ensure their flat parts stay aligned properly without being askew during next attempt either side now either it goes in different single or shared head extruder mode so avoid leaving hole after last component added previously today otherwise see unwanted result afterwards...